Precautions For Dismantling The Linear Guide

What matters need to be followed when disassembling the linear guide. After using the linear guide for a long time, there will always be problems of one kind or another. If you want to find out the problem, you must first disassemble the linear guide, and you must pay special attention in the process of disassembly.

First of all, it is necessary to understand that the end and side of the slider of the linear guide are all plastic components, so it is not allowed to use a hard tool for hammering during the installation, and the workpiece cannot be allowed to be used during the trial operation. If there is any impact on it when it is running at overspeed, if the plastic part is damaged after the impact, the ball will roll out from the inside, and the slider will fall down. Under normal circumstances, the linear guide has been injected with lubricating oil before leaving the factory. If it is to be cleaned, it must be dried in the sun and then added with lubricating oil. The linear guide is not allowed to perform any sliding action without lubricating oil. of.

If there is no special requirement, try not to disassemble the slider from the guide rail. Any disassembly of the linear guide rail components will easily affect its flexibility and accuracy.