What Should Be Paid Attention To in The Installation Of Linear Guides?
Installation of rails
1. Be sure to remove burrs, dents and dirt on the installation reference surface before installation.
Note: Because the slide rail is coated with anti-rust oil, please wash it with cleaning oil before installation. The reference surface after the anti-rust oil is removed is prone to rust. It is recommended to apply a low-viscosity spindle lubricant.
2. After lightly installing the slide rail on the bed, lightly tighten the assembly screw so that the rail and the installation surface are lightly close together. (The reference surface of the bed should be in contact with the side with the marked line of the slide rail
Note: The screws used for installation must be cleaned first, and the specifications and the slide rails must be confirmed before tightening the screws.
3. Tighten the positioning screws of the slide rails in order to make the slide rails closely connect with the steering mounting surface.
4. Using a torque wrench, tighten the assembly screws to the specified torque to make them tightly connected.
Note: The tightening sequence of the slide rail assembly screws is to tighten in sequence from the center position to the end, so as to obtain stability.
5. The rest of the slide rails are also installed in the same way until they are all completed.
6. Tap the special anti-stag cover little by little into the mounting screw holes until it is on the same plane as the top of the slide rail.
Installation of the slider
1. Slowly install the worktable on the slider, and the screws are informally locked
2. Use the positioning screw to contact the reference side of the slider with the reference surface of the side of the table to position the table
3. The assembly screws on the base side and the passive side are officially locked and the installation is completed.
Note: Tighten the assembled screws in the order indicated by the diagonal lines to make the table more evenly fixed.
This method is not time-consuming to find the straightness of the slide rail, and does not require machining of the positioning pins for fixing; therefore, the installation time can be greatly reduced.